How To Turn Off Gas Fireplace Pilot Light. Can you leave the pilot light on a gas fireplace? If you switch your pilot light off, your air conditioner won't have to work as hard to reverse the heating effect of the pilot light.
The gas supply should also be isolated by turning the gas valve located near to or within the fireplace to the off position. Sometimes, you can see that. Open the front of your fireplace, “close” the pilot knob, and also carefully turn.
Table of Contents
1.For Most Fireplaces, All You Will Need To Do Is Open The Front Of The Unit To Access The Pilot, Then Turn The Pilot Light Valve To The Off Position.
Turn your gas valve control knob to “pilot.” do not force pilot light controls or use oil if they are sticky. 26.turn the dial so the arrow or mark on top points to the “off” position. Push in the pilot knob, which manually sends gas into the system.
Depending On How Long It’s Been Since The Gas Fireplace Was Last Used, Ignition May Take Several Attempts Before Igniting.
Turning off your pilot light is a simple process that will save you both energy and money. We recommend that you turn off your gas fireplace pilot light seasonally. Turning off your pilot light is a simple process that will save you both energy and money.
If You Switch Your Pilot Light Off, Your Air Conditioner Won't Have To Work As Hard To Reverse The Heating Effect Of The Pilot Light.
This is an instructional video on how to shut off your standing pilot gas fireplace. Turn the gas control valve to the off position. Sometimes, you can see that.
7.Press This Button And You Should See The Pilot Light Turn On Whenever You Turn The Gas Control To Start The Gas.
Push in the pilot knob, which will then manually send gas into the system. Depending on how long it’s been since the gas fireplace was. After that, wait for 5 minutes for any gas to.
The Gas Supply To The Pilot Light Will Be Cut Off And The Flame Will Go Out.
Can you leave the pilot light on a gas fireplace? Next, light your lighter and put its flame near the pilot light inside the fireplace or furnace, or press the clicker button to make sure that it is sparking (this may be hard to see in some fireplaces). Keep pushing the button until the pilot light turns on.